What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 02.07.2025 09:24
At least they know the answer if they wanted it.
2024–10–16 [ OO OLAOYE OYEBODE ]
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
Have you ever seen your wife being fucked?
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
This is where this question deviates from being a 'generic' question, and becomes more specific.
nine
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
A circuit breaker is similar, but is resettable.
This one hit behind the barn.
What does a fuse do?
I post the exact comment here.
What toxic behavior has been normalized by society?
Barnstars:
Edit 2024–10.
First Sentence:
Because the load is inductive, the current lags the voltage.(by a bit).
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
At one ohm, the resistor has a maximum of 1 watt power.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
He then describes Rainy Season and Lightning.
One
What’s the funniest thing you’ve heard a child cry about?
These devices are installed between the “hot” and “neutral” and protective ground.
An AC voltage/ current source, and an ac inductive load.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
The ‘golden summer of cheap flights’: Now’s the time for last-minute deals - CNN
2024–10–10[John johnson John Johnson ]
[old diagram got deleted by accident]
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
the problem then depends on "how fast does the fuse operate?".
Now when you have a certain ac resistance, then a current flows in a loop.
This device then solves the entire problem.
What do you do when your family doesn’t care about you?
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
2024–10–14 [Omar Gharbi Omar Gharbi ]
[image of Common-mode choke]
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
(Dc diagram shown, AC is similar).
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
But it can get overloaded, and no longer works.
a photo is worth a thousand words.
In schematic diagrams this is the symbol for a fuse:
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
This is 'the assistant's answer'
The other is “what does a “fuse” do?”
Can the fuse protect the electronic devices from lightning instead of a surge protector.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
It also is a device that limits the change in current flow.
Here is a simplified AC power diagram.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
He then asserts :
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
The bolt then partially travels down the line to your home.
The MOV will conduct when the voltage exceeds 50% of line voltage.
It seems Mohan does not understand the difference between a comment and an Answer.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
but I think this circuit , shows a few more pieces.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
But… the neutral is now “floating” because of the 1 ohm resistance.
but this device (an Inductor) … impedes the rapid changes in the current.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
This is the picture of an electronic coil of wire wound around a core of magnetic material.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
There are three different concepts here that are getting confused.
This is where the MOV conducts again, and dissipated the energy.
What is lightning?
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
There are two important concepts here.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
These are simplified answers to the original question, and does not change anything I wrote above.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
So, the voltage could go up to 500 volts, and the fuse will not open up.
so, what happens?
A fuse is a non-resetable over current circuit protector.
One is “what exactly is in a ‘surge protector’ ? ”
He then describes the function of a fuse.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
The third is lightning and “how it gets conducted into a home.”
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Upvotes:
what exactly is a ‘surge’ protector?
eight
For this case there are devices called Metal oxide varistors (MOV).
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.